Audicus/Hansaton hearing aid models

[pvc]

Looking for Audicus/Hansaton models in the following software;

• Connexx6.5.5 HTFit6.21.1100-for-Hansaton for older/Legacy
• Connexx8.3.6.823 HTFit8.3.0-for-Hansaton for Newer/Current
• HANSATON Scout 5.4 for newer/current

By starting the software, selecting a client (Joe Blow, Male, 1/1/1950), initiate a fitting session, and then looking at the various Hearing Instruments.

Not surprisingly, No Audicus hearing instruments show up. But rebranded models don't always show up until you try using the correct hearing aid programming device to "Connect" to the hearing aid. But even then, a rebranded model may still not connect if it has been locked.

 

[pvc]

@Jimmy8881 - The model search can be narrowed-down/more specific if we could narrow-down to the type of hearing instrument you are searching for. For example, using Connexx8.3.6.823 HTFit8.3.0-for-Hansaton we can choose between BTE or RIC;

• BTE = hollow plastic slim tube between hearing aid and ear
• RIC = receiver in ear connected by wire between hearing aid and ear

 

[pvc]

Now for getting more detailed model information; For example; Click the + on model INARA, select a flavor and then click Details. Voila; here is all the technical details because you can click "Open datasheet (PDF)";

 

[pvc]

Follow-up from a PM/Conversation about (Audicus aPearl) being the same model as the (Hansaton Sorino X Micro). You should use the software steps in (Connexx8.3.6.823 HTFit8.3.0-for-Hansaton) as described (above in the previous posts) to obtain detailed model information. For example see SORINO X-Micro models below; Though, I am not sure which sub-model/power you have.

 

[Jimmy8881]

Wow thank you so much for the very detailed information post!